Sie sehen gerade Inhalte für den Standort:
Canada / English
Canada / English Canada / English Long awaited – here is the continuation of our build report on the Aeronaut Comtesse!
Now that the hull has already been completed, we will take you into the next construction phases. In this part, we report on the further work steps, the materials used, and the challenges that arose during the process.
Enjoy reading – and as always, we look forward to your comments and questions!
Here we go. We also want to plank the transom in three layers, as there is enough mahogany material left over. For this purpose, the frame structure was doubled up and then the remaining part in the stern was closed in the same way as the deck.
Now only the rub rails on the bow area and the side strips had to be glued, and we can sand the entire boat and seal it with our HT 2 epoxy resin.
There are no reviews yet. Be the first one to write one.
Austria
Belgium
Belgium
Bulgaria
Croatia
Czech Republic
Denmark
Estonia
Finland
France
Germany
Greece
Hungary
Italy
Netherlands
Norway
Poland
Portugal
Romania
Russia
Serbia
Slovakia
Slovenia
Spain
Sweden
Switzerland
Switzerland
Switzerland
Have you not seen the first part yet? Then take a look here: Part 1