Australia / English
17 February 2025
Aero-Naut “Comtesse” our build report– Part 2 –
- by ScaleMonkey
Long awaited – here is the continuation of our build report for the Aeronaut Comtesse!
Now that the hull has been completed, we are taking you through the next construction phases. In this part, we report on the further work steps, the materials used, and the challenges that arose.
Enjoy the read – and as always, we look forward to your comments and questions!
Continuing here. We also want to plank the transom in three layers, as there is enough mahogany material left over. For this purpose, the frame structure was doubled up and the remaining part of the stern was then closed in the same way as the deck.
Now only the rub rails had to be glued onto the bow area and the side strips, and we can sand the entire boat and seal it with our HT 2 epoxy resin.
the protective strip is glued to the bow
doubling up the frames
the first layer of the stern is glued
the third layer is pressed again
Deine Meinung zähltBewertungen & Feedback
There are no reviews yet. Be the first one to write one.
Haven't seen the first part yet? Take a look here: Part 1