South Africa / English
17 February 2025
Aero-Naut “Comtesse” our build report– Part 2 –
- by ScaleMonkey
Long awaited – here is the continuation of our build report for the Aeronaut Comtesse!
After the hull has already been completed, we are now taking you through the next construction phases. In this part, we report on the further work steps, the materials used, and the challenges that arose along the way.
Enjoy the read – and as always, we look forward to your comments and questions!
Continuing from here. We also want to plank the transom in three layers, as there is enough mahogany material left over. For this purpose, the frame structure was doubled up and then the remaining part in the stern was closed in the same way as the deck.
Now only the rub rails had to be glued onto the bow area as well as the side rails, and we can sand the whole boat and seal it with our HT 2 epoxy resin.
the protective rail is glued to the bow
doubling up of the frames
the first layer of the stern is glued
the third layer is pressed again
Deine Meinung zähltBewertungen & Feedback
There are no reviews yet. Be the first one to write one.
Haven't seen the first part yet? Then take a look here: Part 1